Installation steps of TV hanger 1. Before installing th […]
Installation steps of TV hanger
1. Before installing the TV rack, carefully check the load-bearing capacity of the wall. In many rooms, the internal walls of the compartments are all hollow, and the wall-mounted TV cannot be installed at all, so the TV can only be watched on the cabinet. According to the national "TV Installation Service Standards", the load-bearing capacity of the installation wall should be guaranteed to be no less than 4 times the actual load-bearing capacity of the TV, and the TV should not tip over when it is tilted back and forth 10 degrees after installation.
2. The installation environment is also very important. First of all, let's check the indoor humidity. No matter what brand of TV it is, it cannot be kept in a humid environment for a long time. Because many TVs are not protected against water, the heat dissipation grid The internal circuit board will be in direct contact with the outside air, and the TV installation location is too close to moisture will damage the machine; in addition to the air humidity, you must also look at the installation location of the TV rack. Generally speaking, the distance to watch the TV should be at least the diagonal distance of the display screen. 3-5 times.
3. The purchase of a TV rack is extremely important. Everyone knows that the TV is much lighter than the traditional crt, but if it is not installed well, it is still likely to fall from the back wall, and the consequences are very serious. When choosing a TV flower stand, you must choose the appropriate wall mount bracket, and its strength and durability must be guaranteed.
4. The TV racks need to be classified according to the type of wall, and different walls need different installation methods. If it is an ordinary brick wall to install a TV rack, just punch a hole in the wall with an impact drill, then insert a plastic expansion tube, and finally fix the TV rack with screws and hang the TV.
5. If it is a board wall, then you need to choose the positioning of the TV bracket first, first use a utility knife to make a small hole at the fixed point, and then place a 2cm thick long wooden slat on the TV rotating bracket. Make the self-tapping screw penetrate the gypsum board and enter the wooden slat during self-tapping, so that the force-bearing area is enlarged.
Precautions for installing the TV rack
1. When choosing a TV stand, pay attention to whether the TV hole positions are regular, whether it is four holes, whether it is rectangular or square.
2. When choosing a TV stand, there are many choices when choosing a TV stand, generally divided into ordinary non-adjustable hangers, ordinary adjustable hangers, single cantilever hangers, double-arm hangers, etc. We must be careful when choosing .
3. The installation of the rack is also a very important issue. It is necessary to find a professional personnel to install it, or have a professional to guide by, so as to avoid some safety problems.